Possible to wire 1 sensor (binary/contact) to two different Konnected boards

So right now I have a first gen konnected board that is working perfectly with my home assistant setup, I also run homebridge on a separate piece of hardware.  Since my board is tied into home assistant I can't see any of the zones when it's setup in homebridge (apparently a known issue because it's already registered to another service).  So my question is can I wire up my zones to both boards at the same time so they work together?   Would like to know before I drop $200 on a new pro board (figure I'll get POE at the same time).

Login or Signup to post a comment