I would really appreciate any help that you could provide me with setting up the relay to act as a 'key switch'
I am trying to understand if ...
Should the really be Normally Open or Normally Closed ?
Do you keep the realay open or closed for the period you want it alarmed or should it be used as a momentary switch ?
Is a resistor needed in the wiring, what value and series or parallel ?
Thanks
Hi Nick, I am also stuck at this very same point. I also need help setting this up. The photo shows that I have setup 6 zones successfully and now I am trying to setup the remote arm/disarm keyswitch too. I am assuming that zone 7 is free, but there is a resistor on zone 7 and I am unsure how to wire this up to the relay on the Konnected interface board.
How did you go with this? I hope this reaches you.
Regards
Denny
