In the documentation it shows a diagram of where to connect the piezo buzzer. I don't have these ports on my board. Where should I connect the piezo buzzer in this case?
  • Did you get a single board?  If so, the diagram shows adding it to the add-on board in two different ways.   You will need to:


     

    You can also connect the buzzer to the OUT screw terminal, or any zone 1 - 5 on any Konnected board using male to female jumper wires.

     On a single board install, it seems you will need to use one of the available zones for the buzzer.  

Login or Signup to post a comment